gefran AFE200 Series Instruction Manual page 74

4 - CONFIG DRIVE
Menu PAR Description
4.1 550 Save parameters
Any changes to parameter values immediately affect drive operations, but are not
automatically saved in the permanent memory.
The "Save Parameters" command is used to save current parameter values in the
permanent memory.
Any changes that are not saved will be lost when the drive is switched off.
To save parameters follow the procedure described in STEP 6 of the Startup wizard.
Menu PAR Description
4.2 554 Access mode
With this parameter you can restrict access to advanced configuration.
Easy
0
Expert
1
The Easy mode gives access to a list of parameters that can be used for rapid drive
commissioning. This type of configuration is suitable for the majority of applications.
Setting the parameter to Expert gives access to all the parameters in the firmware.
This mode allows an extremely high level of customization to be achieved in order to
exploit the potential of the AFE200 to the full.
Menu PAR Description
4.3 120 Input inductance
Setting of the input choke value. This is used to calculate the voltage and current
regulator gains.
Menu PAR Description
4.4 458 DC link capacitor
Setting of the value of the DC-link capacitors.
Menu PAR Description
4.5 2020 Take parameters
Stores the choke and capacitor settings. This command must be supplied last after
entering the appropriate values of all the parameters listed above. This involves cal-
culating the voltage and current regulator gains. The drive cannot be started until the
Take parameters command has been set.
Note!
This is not saved permanently. Use the "Save Parameters" command in the DRIVE CONFIG menu to
save in the permanent memory.
Menu PAR Description
4.6 2028 Take status
Indication of the status of parameter saving.
74
UM Type FB BIT
BIT
UM Type FB BIT
ENUM
UM Type FB BIT
mH FLOAT
UM Type FB BIT
uF FLOAT
UM Type FB BIT
BIT
UM Type FB BIT
ENUM
AFE200 • Instruction Manual
Def Min
0 0
Def Min
Facile 0
Def Min
CALCF 0.0
Def Min
SIZE 0.0
Def Min
0 0
Def Min
Required 0
Max Acc
1 RW
Max Acc
1 RW
Max Acc
0.0 RWZS
Max Acc
0.0 RWZS
Max Acc
1 RWZ
Max Acc
0 R