gefran AFE200 Series Instruction Manual page 61

Note !
In the procedures described below, the settings have been made using the AFE200-4450 drive.
Step 1 - Connections
Connect the power supply line and enabling contacts as shown in the diagram in
chapter 5.4.1.
Checks to be performed before powering the drive
•
•
Powering the drive
•
Step 2 - Setting of the capacitor value
The factory setting for the AFE200 capacitor value is displayed. The capacitor
values of the drives connected to the DC BUS must be added to this (value of the
DC-link capacitors). This setting must not be higher than the maximum capacitor
value shown in table 10.4.
T+ T - EN LOC ILim n:0 AL T+
STARTUP WIZARD
01 MONITOR
02 DRIVE INFO Set capacitor value ?
03 STARTUP WIZARD
04 DRIVE CONFIG E=Yes
At the end of the procedure, proceed to Step 3.
Step 3 - Setting of the choke value
The factory setting for the line choke is proposed as defined in chapter 11.2.1. To
change this value, type Enter and follow the instructions or press ▼ to go to step
4.
T+
STARTUP WIZARD
Set induct. value ?
E=Yes
Step 4 - Setting of the DC-link parameter
The factory settings for the DC-link voltage (as a function of the mains voltage)
and acceleration and deceleration times are proposed in sequence. To change the
value type Enter and follow the instructions or press ▼ to go to the next step.
Check that the supply voltage is correct and that the output terminals on the
drive (C, D) are connected correctly.
Check that all the drive control circuit terminals are connected correctly. Check
that all control inputs are open.
After completing all the checks described above, power the drive and proceed
to Step 2.
T- EN LOC ILim n:0 AL T+
S E Q . 0 1
E DC link ca p acitor
Def:
Down=Next
T- EN LOC ILim n:0 AL T+ T-
S E Q . 0 1
E In p ut inductance
Def:
Down=Next
AFE200 • Instruction Manual
T- EN LOC ILim n:0 AL T+ T+ T- T-
PA R : 4 5 8 S E Q . 0 1 1 3 . 0 1
E DC link ca p acitor
Rated voltage
3400 0003400.0 000000400
+
uF
3400.0 Def: Def:
EN LOC ILim n:0 AL T+ T+ T- T-
PA R : 1 2 0 1 3 . 0 1 S E Q . 0 1
E In p ut inductance
Rated voltage
0000.7150
0.7150 000000400
+
mH
0.7150 Def: Def: 0.7150 +400
EN EN LOC LOC ILim ILim n:0 n:0 AL AL T+ T-
E
PA R : 4 5 8 PA R : 1 0 0 S E Q . 0 1
DC link ca p acitor
0003400.1
V V
+400 3400.0 Def:
EN EN LOC LOC ILim ILim n:0 n:0 AL AL T+ T- EN
E
PA R : PA R : 1 2 0 1 0 0 S E Q . 0 1
In p ut inductance
0000.7151
V mH
Def: 0.7150
EN LOC ILim n:0 AL
PA R : 4 5 8
E
V
3400.0
LOC ILim n:0 AL
PA R : 1 2 0
E
mH
61