Mechanical Installation; Inclination And Mounting Clearance - gefran AFE200 Series Instruction Manual

4 - Mechanical installation

The Drive must be mounted on a wall that is constructed of heat resistant material.
While the Drive is operating, the temperature of the Drive's cooling fins can rise to a
temperature of 158° F (70°C).
Le drive doit être monté sur un mur construit avec des matériaux résistants à la chaleur.
Pendant le fonctionnement du drive, la température des ailettes du dissipateur thermique peut
arriver à 70°C (158° F).
Because the ambient temperature greatly affects Drive life and reliability, do not install
the Drive in any location that exceeds the allowable temperature.
Étant donné que la température ambiante influe sur la vie et la fiabilité du drive, on ne devrait
pasinstaller le drive dans des places ou la temperature permise est dépassée.
Be sure to remove the desicant dryer packet(s) when unpacking the Drive. (If not
removed these packets may become lodged in the fan or air passages and cause the
Drive to overheat).
Lors du déballage du drive, retirer le sachet déshydraté. (Si celui-ci n'est pas retiré, il em-
pêche la ventilation et provoque une surchauffe du drive).
Protect the device from impermissible environmental conditions (temperature, humidity,
shock etc.).
Protéger l'appareil contre des effets extérieurs non permis (température, humidité, chocs etc.).

4.1 Inclination and mounting clearance

The AFE200 must be mounted in such a way that the free flow of air is ensured
see
Maximum angle of inclination �����������30° (referred to vertical position)
Minimum top and bottom distance �������150 mm (≥AFE200-71600 = 400mm)
Minimum free space to the front ���������25 mm
Minimum distance between drives �������none
Minimum distance to the side with the cabinet 10 mm
16
paragraph 10.7 Cooling.
≥
150 mm [ 6" ]
≥
400 mm [ 15.75" ] (ADV 7...)
≥
150 mm [ 6" ]
≥
10 mm [ 0.4" ]
≥400 mm [ 15.75" ] (ADV 7...)
AFE200 • Instruction Manual
≥ ≥
10 mm [ 0.4" ] 25 mm [ 0.98" ]