gefran AFE200 Series Instruction Manual page 113

Menu PAR Description
14.2.4 4010 Fieldbus M->S enable
Setting of fieldbus data updating.
0 Disable
1 Enable
If set to 0, the possibility of sending commands and references from the drive PLC via
the fieldbus is disabled.
If set to 1 the possibility of sending commands and references from the drive PLC via
the fieldbus is enabled.
Menu PAR Description
14.2.5 4012 Fieldbus alarm mode
Setting of the Opt Bus Fault alarm generation mode.
0 Off
1 On
If set to 0 the alarm is only generated if the drive is enabled.
If set to 1 the alarm is generated even with the drive disabled.
Menu PAR Description
14.2.6 4014 Fieldbus state
The logic status of the fieldbus connection is displayed. The value depends on the
type of bus that is used.
These logic states are displayed if the selected fieldbus is CANopen:
0 Stop
1 PreOperational
2 Operational
These logic states are displayed if the selected fieldbus is Profibus:
3 Error
4 WaitPRM
5 WaitCFG
6
DataExchange
7 DPError
14.3 - COMMUNICATION/FIELDBUS M2S
Menu PAR Description
14.3.1 4020 Fieldbus M->S1 ipa
14.3.5 4030 Fieldbus M->S2 ipa
14.3.9 4040 Fieldbus M->S3 ipa
14.3.13 4050 Fieldbus M->S4 ipa
14.3.17 4060 Fieldbus M->S5 ipa
14.3.21 4070 Fieldbus M->S6 ipa
14.3.25 4080 Fieldbus M->S7 ipa
UM Type FB BIT
ENUM
UM Type FB BIT
INT32
UM Type FB BIT
ENUM
UM Type FB BIT
FBM2SIPA
FBM2SIPA
FBM2SIPA
FBM2SIPA
FBM2SIPA
FBM2SIPA
FBM2SIPA
AFE200 • Instruction Manual
Def Min
Enable 0
Def Min
0 0
Def Min
Stop 0
Def Min
0 0
0 0
0 0
0 0
0 0
0 0
0 0
Max Acc
1 ERWZ
Max Acc
1 ERWZ
Max Acc
7 R
Max Acc
0 R
0 R
0 R
0 R
0 R
0 R
0 R
113