Delivery Conditions; Inspection, Transport And Storage; Warranty And Liability; Disposal - Bender COMTRAXX CP9 Series Manual

Important information

1.4 Delivery conditions

The conditions of sale and delivery set out by Bender apply. These can be obtained from Bender in printed or
electronic format.
For software products, the "Softwareklausel zur Überlassung von Standard- Software als Teil von Lieferungen,
Ergänzung und Änderung der Allgemeinen Lieferbedingungen für Erzeugnisse und Leistungen der Elektroin-
dustrie" (software clause in respect of the licensing of standard software as part of deliveries, modifications and
changes to general delivery conditions for products and services in the electrical industry) set out by the Zen-
tralverband Elektrotechnik- und Elektronikindustrie e.V. (German Electrical and Electronic Manufacturers' As-
sociation) applies.

1.5 Inspection, transport and storage

Inspect the dispatch and equipment packaging for damage, and compare the contents of the package with the
delivery documents. In the event of damage in transit, please contact Bender immediately.
The devices must only be stored in areas where they are protected from dust, humidity and spray or dripping
water, and in which the specified storage temperatures are not exceeded.

1.6 Warranty and liability

Warranty and liability claims in the event of injury to persons or damage to property are excluded if they can
be attributed to one or more of the following causes:
Improper use of the device.

Incorrect mounting, commissioning, operation and maintenance of the device.

Failure to observe the instructions in this operating manual regarding transport, commissioning, ope-

ration and maintenance of the device.
Unauthorised changes to the device made by parties other than the manufacturer.

Non-observance of technical data.

Repairs carried out incorrectly and the use of replacement parts or accessories not approved by the

manufacturer.
Catastrophes caused by external influences and force majeure.

Mounting and installation with device combinations not recommended by the manufacturer.

This operating manual, especially the safety instructions, must be observed by all personnel working on the de-
vice. Furthermore, the rules and regulations that apply for accident prevention at the place of use must be ob-
served.

1.7 Disposal

Abide by the national regulations and laws governing the disposal of this device. Ask your supplier if you are
not sure how to dispose of the old equipment.
The directive on waste electrical and electronic equipment (WEEE directive) and the directive on the restriction
of certain hazardous substances in electrical and electronic equipment (RoHS directive) apply in the European
Community. In Germany, these policies are implemented through the "Electrical and Electronic Equipment
Act" (ElektroG). According to this, the following applies:
Electric and electronic equipment are not to be included in household waste.

Batteries and accumulators are not to be included in household waste but must be disposed of in

accordance with the regulations.
Old electrical and electronic equipment from users other than private households which was introdu-

ced to the market after 13th August 2005 must be taken back by the manufacturer and disposed of
properly.
For more information, refer to our website at www.bender.de -> Service & support.
CP9xx_D00349_07_M_XXEN/01.2020 7