General Safety Instructions; Intended Use - Bender COMTRAXX CP9 Series Manual

1.8 General safety instructions

Part of the device documentation in addition to this manual is the enclosed supplement " Safety instructions
for Bender products".
Only qualified personnel are permitted to carry out the work necessary to in-
stall, commission and run a device or system.
Risk of fatal injury due to electric shock!
Touching live parts of the system carries the risk of:
 
DANGER
 
 
Before installing and connecting the device, make sure that the installa-
tion has been de-energised. Observe the rules for working on electrical ins-
tallations.
If the device is being used in a location outside the Federal Republic of Germany, the applicable local standards
and regulations must be complied with. The European standard EN 50110 can be used as a guide.

1.9 Intended use

CP9xx alarm indicator and operator panels show alarms, measured values and states of devices.
These include, for example:
All Bender devices with BMS bus or BCOM interface

Bender devices (PEM, energy meters,...) with Modbus RTU or Modbus TCP interface

Other devices with Modbus RTU or Modbus TCP interface

In addition, the data is available via the Modbus TCP protocol. This allows coupling to a higher-level building
control system as well as visualisation and evaluation using standard web browsers.
Operation and settings are made via the COMTRAXX® user interface integrated in the device.
Any other use than that described in this manual is regarded as improper.
8
An electric shock
Damage to the electrical installation
Destruction of the device
Important information
CP9xx_D00349_07_M_XXEN/01.2020