Printing Pressure Release Arm Gap Adjustment - Ricoh JP5000 Service Manual

1 July, 1998

6.10.4 PRINTING PRESSURE RELEASE ARM GAP ADJUSTMENT

PURPOSE: To ensure that printing pressure release lever is disengaged when
the printing pressure release solenoid is energized.
[A]
1. Rotate the printing pressure cams so that the arm moves to the lower most
position.
NOTE: Use the main drive rotation knob. When the top of the cam meets the
bearing [A] during turning the knob, the arm is at to the lower most
position.
2. Adjust the clearance between the hook and the printing pressure release arm
by moving the bracket [B] up and down. The clearance must be 0.2 ± 0.1 mm.
3. Do the same at the non-operation side.
[B]
6-81
PRINTING SECTION
0.2 ± 0.1 mm
C229R010.WMF