Ricoh JP5000 Service Manual page 239

DRUM
0 to 0.3 mm
CAUTION: 1) Do not scratch the cloth screen or metal screen.
2) Make sure that the correct end of the metal screen is
3) When attaching the metal screen to the drum flanges, wrap it so
4) When installing the master clamper [C], make sure that it is the
5) Do not allow the inside of the master clamper to become dirty
6) Use a cloth dampened with water to clean the inside of the
0 to 0.3 mm
C229R110.WMF
overlapping. (Refer to the lower right part of the upper
illustration.)
that the gap is correct. (Refer to the upper part of the upper
illustration.)
correct way around. The side with the sandpaper [B] must be
facing the black patch [A].
with ink. If it is dirty with ink, the master may slip off and the
image position on the prints will move toward the trailing edge of
the print during a printing run.
master clamper. Do not use alcohol or other solvents. The
clamping force of the magnet will be weakened.
The standard position for the metal
screen (the left side overlaps, as
viewed from the operation panel).
Operation Side
6-48
1 July, 1998
[A]
C229R111.WMF
[B]
[C]