Ricoh JP5000 Service Manual page 288

1 July, 1998
[A]
29. Set the drum drive-securing tool once again. (See step 18.)
CAUTION: Do not turn the drum drive disk by force while setting the tool. If you
turned the disk, return to step 27 then do step 28.
30. Secure the pressure cylinder drive gear [A] (2 screws).
CAUTION: Don't turn the gear by force while securing it.
31. Install the printing pressure cam drive gear and firmly tighten the 2 screws [B].
NOTE: 1) To remove gear play, secure the cam drive gear while turning it
counterclockwise (as viewed from the rear).
2) Secure the cam drive gear by tightening the two screws in the
middle of the curved oval holes. This allows for the maximum
adjustable range for later repositioning of the gear.
MAIN DRIVE AND IMAGE UP/DOWN SHIFTING DRIVE SECTION
[B]
6-97
C229R079.WMF