Ricoh JP5000 Service Manual page 287

MAIN DRIVE AND IMAGE UP/DOWN SHIFTING DRIVE SECTION
27. Remove only the drum
drive-securing tool (leave
the two positioning
shafts). Then turn the
main motor [B] clockwise
by hand until the drum
drive disk [C] has turned
about 10 degrees, as
shown.
NOTE: Although the
motor will not turn
smoothly since
the drive is
secured with the
special tools, this
is normal.
28. Turn the main motor [A]
counterclockwise, and set
the drum drive disk [B] in
the home position. (If the
disk is turned too much at
this point, reset from step
26.)
CAUTION: These steps are needed to put gear play in the direction opposite to
the printing direction. Make sure to turn the main motor by hand in
the above order (steps 27 and 28). If the motor is turned in wrong
order, the main drive will turn slightly when the two shafts (special
tools) are removed. If you turned it in the wrong order, return to
step 27 then do step 28.
[C]
[B]
[B]
[A]
6-96
1 July, 1998
C229R535.WMF
C229R536.WMF