Ricoh JP5000 Service Manual page 132

INSTALLATION PROCEDURE
[D]
A628O031.WMF
ADF harness installation
1. Remove the rear cover (6 screws) and the DF connector cover (2 screws).
2. Swing out the MPU bracket [A] (6 screws).
3. Run the DF harness (accessory), as shown, and fasten it with the clamps [B] (5
clamps), which were originally used in the main body.
4. Connect the cable connector [C] to CN216 on the I/O board.
5. Attach the connector [D] at the opposite end to the connector bracket (2
screws).
[B]
3-12
1 July, 1998
[A]
[C]