1 July, 1998
6.9.3 PAPER WIDTH DETECTION BOARD
First, remove the rear cover
(3 screws).
B: Paper table rear cover
NOTE: Carefully push
out the 2 hooks
[A] with a
screwdriver.
C: Sensor cover (2 screws)
D: Paper width detection
board (1 screw, 1
connector)
6.9.4 PAPER HEIGHT SENSOR
First, remove the master
making unit (see 6.7.1 Master
Making Unit Removal).
A: Feed cover (2 screws)
B: Paper height sensor (1
screw, 1 connector)
NOTE: When reinstalling
the master making
unit, push it in
while pressing the
rail with a
forefinger. Then
secure the screws.
[C]
[B]
6-59
PAPER FEED SECTION
[D]
[A]
[B]
C229R033.WMF
C229R035.WMF
[A]