Ricoh JP5000 Service Manual page 181

6. SYSTEM ADJUSTMENT
SP No. Display
6-117-2 Regist Delay - 20 rpm Do not adjust.
Regist Delay - 30 rpm
6-117-3
6-117-4 Regist Delay - 60 rpm
6-117-5 Regist Delay - 75 rpm
6-117-6 Regist Delay - 90 rpm
6-117-7 Regist Delay - 105
rpm
6-117-8 Regist Delay - 120
rpm
6-118-1 A4 Skip Regist Delay
16 rpm
6-118-2 Regist Delay - 20 rpm
6-118-3 Regist Delay - 30 rpm
Regist Delay - 60 rpm
6-118-4
6-118-5 Regist Delay - 75 rpm
Regist Delay - 90 rpm
6-118-6
6-118-7 Regist Delay - 105
rpm
6-118-8 Regist Delay - 120
rpm
6-130 Drum Master Clamp
Regist
Notes
1: 6-001 (Main scan position)
Inputting a positive number moves the image away from the operation side of the
machine. Use the point ( . ) key to switch between + and –.
2: 6-002 (Scan start position)
Inputting a positive number moves the image away from the leading edge of the
printer paper. Use the point ( . ) key to switch between + and –.
3: 6-010 (Master writing speed)
This changes the master feed motor speed.
Inputting a positive value stretches the image on the master. Inputting a negative
value shrinks it.
Normally, do not use this SP mode to adjust the vertical magnification. Use it only if
the vertical magnification is not satisfactory by adjusting Scanning Speed (SP6-
011).
4: 6-011 (Scanning speed)
Inputting a positive value stretches the image on the master. Inputting a negative
value shrinks it.
5: 6-050 (Operation panel LCD contrast)
0: Palest, 7: Darkest
Function
Do not adjust.
See Note 11.
4-44
1 July, 1998
Default Settings
34 0 to 255
34 0 to 255
30 0 to 255
27 0 to 255
23 0 to 255
18 0 to 255
12 0 to 255
34 0 to 255
34 0 to 255
34 0 to 255
30 0 to 255
27 0 to 255
23 0 to 255
18 0 to 255
12 0 to 255
0 -10.0 to
10.0mm