Ricoh JP5000 Service Manual page 269

PRINTING SECTION
4. Then, put the pressure cylinder
into the hole where the drum
was using both hands.
5. Install the pressure cylinder,
while positioning the thinnest
part of the shaft of the bearing
[A] with the clamper cam (the
black cam) as shown to the
right. Position the bearing [A]
on the bearing holder.
6. While the round hole [B] is
uppermost, push the pressure
cylinder towards the non-
operation side (to engage the
joint behind the cylinder).
NOTE: 1) If it cannot enter, push
while turning the
pressure cylinder a
little. Check if the joint
is engaged properly by
turning the cylinder
slightly.
2) Set the bearing stopper
[C] as shown.
6-78
1 July, 1998
[A]
C229R538.WMF
[B]
[C]
C229R006.WMF