Printing The Test Labels - Avery Dennison SNAP 700 Operator's And Service Manual

22

2.6.4 Printing the Test Labels

1. Press the Start button. The stacker (if installed) will move the platform to its
2. If any problems occur, either the Supply or Error light will come on. If this
3. If you can't get the printer to run, refer to sections 10 and 11 Troubleshooting.
start position and the printer will begin printing the test labels. If there is no
stacker installed there will be a noticeable delay in the start of the printer.
happens, press the Voice button and the printer will say a message telling what
the problem is. Correct the problem and press the Start button again. Repeat
this until the printer runs continuously.
User's Manual—SNAP™ 700 Printer