Getting The Upg File; Getting Upg File Using D2Comm; Getting Upg File Without Using D2Comm - Avery Dennison SNAP 700 Operator's And Service Manual

70
MachSpeed P4MDPT
Chaintech MP4M26A
Epox EP-P4MKI-EP
Biostar U8668-D
Biostar MCP6P M2+
If you have one of the following motherboards, you will need 3.30.16.15

7.3 Getting the UPG file

7.3.1 Getting UPG file using D2Comm

7.3.2 Getting UPG file without using D2Comm

You may download the upgrade file as follows:
1. Go to www.monarch.averydennison.com.
2. On the left, click "SUPPORT", then "Printer Utilities, Firmware & Drivers"
3. Next in the Firmware second (2
The easiest way to get the UPG file is through D2Comm. If you have a D2Comm
account,
request your D2Comm Coordinator to schedule an upgrade for your
•
account.
Log in to D2Comm, select "In Plant", and then "Retrieve Updates".
•
The upgrade file will automatically download.
•
Start PCMate to upgrade. There is no need to unzip this file as it will
•
already be a UPG file.
& SNAP 700"
Red color
"P4KDPT" printed on board
Yellow/gold color
Chaintech" printed on heat sink next to processor
Fourth line of the BIOS reads "MP4M266A"
Green color
"EP-P4MKI-EP" printed in white on the motherboard
near the memory slots.
Fourth line of BIOS reads "10/01/2004 for Apollo
P4M266A Chipset"
Red/purple color
"U8668-D printed on motherboard near memory slots.
Fourth line of BIOS reads "U8668-R35-D"
Blue in color
"MCP6P M2+" printed next to heat sink. Connector
block on back of printing missing parallel port connector
(25 pin D-shall above serial and video connectors)
nd
one down), click "Apparel Models – SNAP 500
User's Manual—SNAP™ 700 Printer