Print - Avery Dennison SNAP 700 Operator's And Service Manual

82

8.3 Print

Problem
Stock advances but the
printer does not print.
Machine stops after
every third label.
Print registration is off in
the feed direction.
Print registration is off in
the web direction.
Probable Cause
1) Stock registration sensor is
misaligned (preprinted stocks
only).
2) Print head
disconnected or faulty.
3) Print head is faulty.
4) Stock and Ink Transfer Type
selection in
doesn't match supplies.
1) Stock registration sensor is
misaligned (preprinted stocks
only).
2) Label length selection in the
Design File doesn't match the
printed stock length.
1) Print position is incorrect.
2) Field(s) position incorrect in
the Design File.
3) Sense–to–cut selection in the
Design File is incorrect.
4) Bound print roller.
1) Machine is
threaded.
2) Web guides
adjusted.
3) Stock Arbor is not tight.
IF THE RECOMMENDED CORRECTIVE ACTIONS DO NOT
RESOLVE THE PROBLEM (S), CONTACT YOUR LOCAL
AVERY DENNISON REPRESENTATIVE.
1) Re-align sense mark with sensor, refer to
section 3.3.6.2 Sensors.
cable is 1) Power off the machine and reinsert the
print head connector or replace the cable.
1) Replace the print head.
1) Refer to the PCMate Platinum software
Design File manual.
1) Refer to the PCMate Platinum software
manual.
1) Use the Virtual Control / Display or adjust
the print position.
1) Refer to PCMate Platinum software
manual.
1) Refer to PCMate Platinum software
manual.
1) Check that the print roller turns freely on its
shaft. If it does not, replace it.
incorrectly 1) Check and rethread the media as needed.
Refer to section 3.1.3 Loading the Stock.
incorrectly 1) Check and adjust web guides as needed.
Refer to section 6.2, Stock (Web) Guide
Width Adjustments.
1) Check and adjust as needed.
section 3.1 Loading Supplies.
User's Manual—SNAP™ 700 Printer
Corrective Action
Refer to