Printer Configurations - Avery Dennison SNAP 700 Operator's And Service Manual

16

2.4.1 Printer Configurations

The Upper and Lower Ink Arbors are adjusted using the black knob on the
•
end of the arbor. To open up and close down the self-center arbor to the ink
cores rotate the knob. Do not over tighten onto the core to hole them in
place. They accommodate ink rolls ranging from 1 inch (25mm) to 5 inches
(127 mm) cores.
A Rotary Knife Assembly comes with printer. When printing woven tapes,
•
use a Sonic Knife accessory option that provides ultrasonic cutting and
sealing.
The Stacker collects the finished, printed labels. You can adjust it to
•
accommodate a variety of label stocks and short or long labels. Once the
stacker reaches the bottom, the printer will stop, indicate the stacker is full,
and allow you to remove the labels.
The Control Panel with buttons and LED's indicate printer status and
•
information about specific jobs.
WARNING: This is a class A product. In a domestic environment
this product may cause radio interference in which case the user
may be required to take adequate measures.
The Snap 700 comes in 2 configurations:
1 over 1 – The Snap 700 1 over 1 features one upper print head over one
•
lower print head, capable of printing a two sided label.
1 over 0 – The Snap 700 1 over 0 features one print head on top only.
•
User's Manual—SNAP™ 700 Printer