Checking The Software Version; Printing A Test Label - Avery Dennison 6059 Operator's Handbook Manual

C h e c k i n g t h e S o f t w a r e V e r s i o n
To check the printer's software version: <- Where is this?
1. Turn on the printer.
2. From the printer's Main Menu, use  or  until you see Configuration, then press Enter.
3. Use  or  until you see Version, then press Enter.
The printer's version number is displayed. Press ESC to return to the previous menu.
4. Press ESC until you return to the Main Menu.
P r i n t i n g a T e s t L a b e l
To print a Test Label: <- Where is this?
1. From the printer's Main Menu, use  or  until you see Diagnostics, then press Enter.
2. Use  or  until you see Printer, then press Enter.
3. Use  or  until you see Test Labels, then press Enter.
4. Select from the following test labels:
Select:
Diag Label
Test Pattern
5-2 Operator's Handbook
The following labels print:
Prints a label with version numbers, voltage, printhead information
and blackmark sensor values.
Model: M6033
PE Firmware Rev: AB
PE Hardware Rev: AB
PE Voltage: 7.92 V
PE Current: 107 mA
PH Avg. Resistance: 347 ohms
Num Bad dots 0
PH Temperature (raw) : 697
Blackmark sensor: 1.56 V
Classification: Avery Dennison – Public
Prints a label to verify that the printhead strobes
are working. If your printed sample has fewer lines
or no lines, keep the sample and call Service.