Sp Reset, Settings P14L1 To P14L4; Sp Comm, Setting P15L1 - Eaton MP-3000 Instruction Leaflet

IM02602002E
5.13.7 Setting P13L7, State of Discrete Input 1 (DI1 ON or Off)
P13L7 is read-only - not a setting. Use this setting to determine if
Discrete Input 1 is ON (energized) or OFF.
5.13.8 Setting P13L8, State of Discrete Input 2 (DI2 ON or Off)
P13L8 is read-only - not a setting. Use this setting to determine if
Discrete Input 2 is ON (energized) or OFF.
5.14 Page 14, SP RESET, Settings P14L1 to P14L4
Page 14 is used to reset or clear the accumulated history mode statis-
tics on the History pages.
• Press the line button on the History page to clear.
• Press either Value button to get the PUSH RST display.
• Press the Reset pushbutton to clear the History page.
• To escape without clearing, do not push Reset. Use a Value
button to change from PUSH RST back to [History Page
Name] RST, then navigate elsewhere or exit the Program
Mode.
Page 5-12
MP-3000
The four History pages are:
• Setting P14L1, Motor History Reset (MTR RST);
• Setting P14L2, Trip History Reset (TRIP RST);
• Setting P14L3, Alarm History Reset (ALRM RST); and
• Setting P14L4, History Totals Reset (TOT RST).
Refer to Section 4 for more information on the History Mode displays
that can be cleared.
5.15 Page 15, SP COMM, Setting P15L1
Setting P15L1 is used to enable (on) or disable (off) the RS-232 com-
munications mode. Note that URTD and PONI communications are
disabled when in the RS-232 mode. Be sure that the PowerNet is set
to greater than 0; otherwise, the unit will not communicate.
www.eaton.com