Areas Of Application And Usage Restrictions; Safety; Explanation Of Warning Symbols; Structure Of The Safety Instructions - Otto Bock C-Brace Instructions For Use Manual

The orthosis is intended for exclusive use by one user. Use of the product by another person is
not approved by the manufacturer.

3.5 Areas of Application and Usage Restrictions

CAUTION
Excessive strain or overloading of the orthosis due to unusual activities
Falling or skin irritation may result, caused by:
► Malfunction of the orthosis due to short circuits in the electronics and battery.
Breakage of load-bearing components.
►
► Damage to the battery.
► Hydraulic unit defects with associated leakage of liquid.
→ The orthosis was developed for everyday use and must not be used for unusual activities
such as extreme sports (free climbing, paragliding, etc.).
→ If the orthosis has been subjected to extreme strain (e.g. due to falling or similar), it must be
inspected by a CPO immediately for possible damage. The contact person is the respons­
ible CPO, who will send the orthosis to Ottobock Service if necessary.
The orthosis is an orthopaedic device that makes it possible or easier for the user to stand and
walk, and may also fulfil other medical requirements. The Ottobock team has adapted the orthosis
to the loads expected at the time of fitting. If the activity level increases in the course of use,
adjustments are required. Changes will also have to be made if the user's physical condition wor­
sens and more support from the orthosis is needed.
The daily duration of use and potential therapeutic measures (e.g. occupational therapy or physio­
therapy) to improve performance must be discussed with the attending doctor. In general, major
discomfort should not be experienced when wearing the orthosis. Excessive pressure can lead to
complications.
Please contact the attending doctor or Orthotist for any questions or in case of problems with the
orthosis.

4 Safety

4.1 Explanation of Warning Symbols

WARNING
Warnings regarding possible risks of severe accident or injury.
CAUTION
Warning regarding possible risks of accident or injury.
NOTICE
Warning regarding possible technical damage.

4.1.1 Structure of the Safety Instructions

The safety instructions are structured according to the ANSI standard and are introduced with the
degree of severity:
CAUTION
The heading identifies the source and/or the type of hazard
The introduction describes the consequences in case of failure to observe the safety instruc­
tions. In case of several consequences, these are presented as follows:
Ottobock | 35