Advanced User Guidebook - Owon TAO3000 Dual-Channel Series User Manual

4.Advanced User Guidebook

4. Advanced User Guidebook
Up till now, you have already been familiar with the basic operations of the function
areas, buttons and knobs in the front panel of the oscilloscope. Based the
introduction of the previous Chapter, the user should have an initial knowledge of
the determination of the change of the oscilloscope setting through observing the
status bar. If you have not been familiar with the above-mentioned operations and
methods yet, we advise you to read the section of Chapter 3 "Junior User
Guidebook".
This chapter will deal with the following topics mainly:
 How to Set the Vertical System
 How to Set the Horizontal System
 How to Set the Trigger/Decoding System
 How to Implement the Sampling Setup
 How to Implement the Auxiliary System Function Setting
 How to Set the Display System
 How to Save and Recall Waveform
 How to Record/Playback Waveforms
 How to Clone and Recall a waveform
 How to Update your Instrument Firmware
 How to Measure Automatically
 How to Customize an Automatic Measurement
 How to Measure with Cursors
 How to Use Mathematical Manipulation Function
 How to Use Autoscale function
 How to Use HOR function
 How to Use FFT function
 How to Use XY format
 How to Use Pass/Fail function
 How to Use Executive Buttons
 How to Print the Screen Image
It is recommended that you read this chapter carefully to get acquainted the
various measurement functions and other operation methods of the oscilloscope.
22