Messages List - Sony VPL-PHZ10 Operating Instructions Manual

Messages List

When any of the messages listed below appears on the projected image, address
the problem in accordance with the table below.
Messages
Clean the filter.
Projector
temperature is high.
Switching to High
Altitude Mode.
Clean the filter.
Projector
temperature is high.
The light will turn off
in 1 minute.
Frequency is out of
range!
Please check Input-A
Signal Sel.
Not applicable!
The control keys are
locked!
Light Dimming
68
Messages List
Meaning/Remedy
Temperature in the projector has increased.
As a countermeasure against use at an altitude of
1,500 m or higher, set "High Altitude Mode" to "On."
If you are not using the projector at a high altitude,
perform the remedies below and set "High Altitude
Mode" to "Off."
Check that the air filter is clogged, then clean or

replace it.
Check that the ventilation holes (intake/exhaust)

are not blocked by a wall or an object and secure a
sufficient gap.
Check the ambient temperature and use the

projector within the range of operating
temperature.
Temperature in the projector has increased.
Perform the remedies below.
Check that the air filter is clogged, then clean or

replace it.
Check that the ventilation holes (intake/exhaust)

are not blocked by a wall or an object and secure a
sufficient gap.
 Check the ambient temperature and use the
projector within the range of operating
temperature.
"High Altitude Mode" on this projector is set to

"On." Set the setting that suits the operating
environment.
Change the output setting of the connected
equipment to one for signals supported by the
projector.
Set "Input-A Signal Sel." to "Auto" or select the input
signal type to suit to the input signal.
Invalid key was pressed.
"Control Key Lock" is set to "On."
Reduces light output when "With Static Signal" is
set. When any change in signal is detected, or an
operation (remote control or control panel) is
performed, normal brightness is restored.
Page
4, 73
4, 73
80
35
6
33
36