Sony VPL-PHZ10 Operating Instructions Manual page 50

Start Advertisement Service:
Set Advertisement to enabled or
disabled. Items for
Advertisement are enabled only
when this function is enabled.
The function is disabled at the
factory default.
-Community:
Input the community name for
Advertisement and PJ Talk. If the
community name for
Advertisement is changed, the
one for PJ Talk will also be
changed. Only four
alphanumeric characters can be
input. The factory default setting
is "SONY." It is recommended
that the community name be
changed from the factory setting
to avoid unnecessary access to
the projector from other
computers.
-Port No.:
Input the transmit port of
Advertisement. The factory
default setting is "53862."
-Interval:
Input the transmission interval
(seconds) of Advertisement. The
factory default setting is "30."
-Broadcast Address:
Input the destination of data via
Advertisement. If nothing is
input, the data will be broadcast
in the same subnetwork.
50
Using Network Features
(b) Set ADCP.
ADCP Service setting area
ADCP button
Start ADCP Service:
Set ADCP to enabled or disabled.
Items for ADCP are enabled only
when this function is enabled.
The function is enabled at the
factory default.
-Requires Authentication:
Set the authentication for ADCP
to enabled or disabled. The
password is the same as that of
the Web page administrator.
-Port No.:
Input the server port of ADCP.
The factory default setting is
"53595."
-Timeout:
Input the time (seconds) until
ADCP communication is
terminated in case it is
disconnected. The factory
default setting is "60."
-Host Address:
Input the IP address that the
ADCP server is allowed to
receive. If no IP address is input,
receiving commands will be
allowed from any IP address.
From the moment the IP address
is input, access will be allowed