Table of Contents
Advertisement
Messages List
When any of the messages listed below appears on the projected image, address the problem in
accordance with the table below.
Messages
Please clean the filter.
Please replace the Lamp
and clean the Filter.
High temp.! Lamp off in
1 min.
Frequency is out of
range!
Please check Input-A
Signal Sel.
Not applicable!
The control keys are
locked!
Projector will shutdown
soon
Press ?/1 Key to Restart
Lamp Dimming
Meaning/Remedy
Clean the air filter.
Replace the lamp with a new one and clean the air filter. The
message appears whenever you turn on the power until you
replace the lamp and reset the lamp timer.
A temperature rise is detected in the unit. Follow the following
instructions.
• Check if the air filter is clogged, then clean or replace it.
• Check if the ventilation holes (intake/exhaust) are not
blocked by walls, etc., then keep enough space around the
unit.
• Check the ambient temperature around the unit. Use the unit
within the operating temperature range.
Change the output setting of the connected equipment to one
for signals supported by the projector.
Set "Input-A Signal Sel." to "Auto" or select the input signal
type to suit to the input signal.
Invalid key was pressed.
"Control Key Lock" is set to "On."
The ?/1 key was pressed and the projector will be shut down
soon. To cancel shutdown, press the ?/1 key again (the
projector will remain on). To turn off the projector directly,
press and hold the ?/1 key for a few seconds.
Reduces lamp output when "With Static Signal" is set. When
any change in signal is detected, or an operation (remote
control or control panel) is performed, normal brightness is
restored.
Page
40
38, 40
10,
10,
31, 40
46
29
–
28
21
29
35
Messages List
Advertisement
Table of Contents
