Sony VPL-PHZ10 Operating Instructions Manual page 14

Connecting to the video equipment
INPUT D
Video equipment
Notes for connecting this unit and the HDBaseT transmitter
• Ask a professional or Sony dealer to perform wiring. If wiring is not correct, the
transmission characteristics of the cable will not be achieved, and image or
sound may break up or you may experience unstable performance.
• Connect the cable directly to the HDBaseT transmitter without going through a
hub or router.
• Use cables that meet the following conditions.
- CAT5e or higher
- Shielded type (covering connectors)
- Straight wire connection
- Single wire
• When installing the cables, use a cable tester, cable analyzer, or similar device to
check if the cables meet the CAT5e or higher requirement. If there is a transit
connector between this unit and the HDBaseT transmitter, include it when
measuring.
• To reduce the affect of noise, install and use the cable in a manner where it is not
rolled up and it is as straight as possible.
• Install the cable away from the other cables (especially the power cable).
• When installing multiple cables, do not bind them and keep the running parallel
distance as short as possible.
• The transmittable distance of the cable is 100 m (approx. 328 feet) maximum. If
it exceeds 100 m (approx. 328 feet), it may cause the image or the sound to break
up, or cause a multifunction in LAN communication. Do not use the HDBaseT
transmitter beyond the transmittable distance.
• Inquire about operation or function problems caused by other manufacturer's
devices with the relevant manufacturer.
14
Connecting the Projector
HDMI output
terminal
HDMI cable (not supplied)
LAN cable: STP type (CAT5e or
higher, straight, not supplied)
HDBaseT transmitter