Sony VPL-PHZ10 Operating Instructions Manual page 36

Setting items
Standby
*15
Mode
Direct Power On
Notes
*1: To set the IP address manually, select "Manual", press "Apply", then enter the IP
address.
*2: Reflecting changes in WLAN settings may take a few moments.
*3: If the projector cannot connect wirelessly, click [Apply] once again to make sure the
connection is established. For details, see "Setting the WLAN Network of the
projector" (page 45).
*4: The factory default settings for "Access Point" are as follows.
SSID: VPL + MAC address for LAN
Security Method: WEP(64bit)
Wireless Password: sony1
To change the settings for "Access Point", use a Web browser.
For details, see "Setting the WLAN Network of the projector" (page 45).
*5: For changing the settings for "Client," use the Web browser for change. For details,
see "Setting the WLAN Network of the projector" (page 45).
*6: If the image input setting of the HDMI connection equipment is not correct, the
brighter part becomes too bright and the darker part becomes too dark.
*7: This may not be optimum depending on the input signal. In this case set manually
according to the connected equipment.
*8: This mode does not work for about three minutes after the light lights. A change in
signal may not be detected depending on the input image. The light may become
36
The Connection/Power Menu
Item descriptions
With Static Light Dimming
Signal change for about 10 seconds, light output is
gradually reduced (approximately 10% to
*14
15%
Automatically the light slowly darkens to
approximately 5% of its light output according
to the selected time (with no change to input
signal) "5 min.", "10 min.", "15 min.", "20 min." or
"Demo.", While dimming the light, the message
"Light Dimming" appears. If you select "Demo.,"
the image will start to darken about 40 seconds
later. When any change in signal is detected, or
an operation (remote control or control panel) is
performed, normal brightness is restored.
Off: You can deactivate the With Static Signal.
Standard/Low: When set to "Standard," power consumption
becomes higher in Standby mode. For details, see "Power
consumption (networked standby mode)" in "Specifications"
(page 77).
On/Off: When set to "On", you can turn the power on without
going to Standby mode when the AC power cord is connected
to a wall outlet. With the projector turned off, you can also
unplug the AC power cord without going to Standby mode,
regardless of the Direct Power On setting.
*8 *12 *13
: If an image does not
) from that set in the Light Output Mode.