The Operation Menu - Sony VPL-PHZ10 Operating Instructions Manual

The Operation Menu

The Operation menu is used for setting for the operations by using the menu or the
remote commander.
Setting items Item descriptions
Language Selects the language used in the menu and on-screen displays.
Menu Bottom Left/Center: For selecting the position of the menu displayed
Position on the projected image.
Status On: All on-screen statuses are enabled.
Off: Displays only the menus, the message when turning off the power,
and warning messages.
IR Receiver Front & Rear/Front/Rear: Selects the remote control receiver (IR
Receiver) on the front and rear of the projector.
Security On/Off: This function enables restriction of the projector to authorized
*1
Lock users by password. The setting procedures for security locking are as
follows:
1 Select "On" and press the ENTER key to display the setting menu.
2 Input the password with the MENU, /// and ENTER keys.
(The default setting password is "ENTER, ENTER, ENTER, ENTER.")
3 Input a new password with the MENU, /// and ENTER keys.
4 Enter the password again to confirm.
Enter the password when you turn on the projector after disconnecting
and reconnecting the AC power cord.
When it is set to "Off," you can cancel the security lock. You are required
to input the password again.
If you fail to enter the correct password after three consecutive times,
the projector cannot be used. In this case, press the / key to go
Standby mode then turn on the power again.
Control Key On/Off: When set to "On," locks all the control panel keys of the
Lock projector. However, you can operate the following when set to "On":
Press and hold the / key for approximately 10 seconds during

Standby mode.
 The projector turns on.
Press and hold the MENU key for approximately 10 seconds during

power on.
 "Control Key Lock" is set to "Off" and enables operation of all
keys on the projector.
Note
*1: You will not be able to use the projector if you forget your password. If you call
qualified Sony personnel because you have forgotten the password, you will be
asked to verify the projector's serial number and your identity. (This process may
differ in other countries/regions.) Once your identity has been confirmed, we will
provide you with the password.
The Operation Menu
33