Sony VPL-PHZ10 Operating Instructions Manual page 52

-Requires Authentication:
Set the authentication for PJ Link
to enabled or disabled.
-Password:
Input the authentication
password for PJ Link. For the
factory default password, refer to
the PJ Link specifications.
(e) Set the system service.
System service setting area
Service button
Start DDDP Service:
Set DDDP to enabled or disabled.
For details, refer to the DDDP
specifications in the reference
from AMX Corporation. The
function is disabled at the factory
default.
Crestron Control:
For details, refer to the
specifications in product
catalogues, etc., from Crestron
Corporation.
-IP Address:
Input the Crestron system server.
-IP ID:
Input the IP ID for the CIP
protocol.
-Port No.:
Input the port number for the CIP
protocol server.
52
Using Network Features
(f) Set the IP Control Sync.
*1
function
IP Control Sync.
IP Control
Sync. button setting area
-Power:
Set to enabled to change the
power status of the projector
that the unit is trying to
synchronize with to the same
status on the unit when you
turn/off the unit.
-Input:
Set to enabled to change the
input connector of the projector
that the unit is trying to
synchronize with to the same
one on the unit when you
change the input connector on
*2
the unit.
-IP Address:
Input the IP address of the
projector that the unit is trying to
synchronize with.
Notes
*1: Enable the PJ Link function of the
projector the unit will synchronize
with, and then set the
authentication and password of
PJ Link in the same way as on the
unit.
*2: The input connectors may not be
changed depending on the