Sony VPL-PHZ10 Operating Instructions Manual page 35

Setting items
*6
Dynamic Range
Input-A Signal Sel.
ECO
Light Output
Mode
Constant
*10
Brightness
Auto Power Saving
Item descriptions
Sets the image input level of the INPUT B/C/D terminal.
Auto: Distinguishes the image input level automatically.
Limited: Set when the image input level is 16-235.
Full: Set when the image input level is 0-255.
Auto/Computer/Video GBR/Component: When set to
"Auto", selects the type of video signal input automatically
when "Input-A" is selected.
Standard/Middle/Low/Auto
image becomes brighter, and power consumption becomes
higher. When set to "Low," power consumption is minimized;
however, the image will be darker. If you select "Middle", the
brightness of the image and power consumption change to
the middle of "Standard" and "Low." When set to "Auto,"
brightness is adjusted automatically according to image
content. Dark images are projected with brightness adjusted,
leading to energy-saving. Bright images are projected
brightly, without adjusting brightness.
On/Off: Available when Light Output Mode is set to
"Standard" or "Middle." Brightness is constant at about 90% of
light output of each mode.
With No Light Cutoff: The light turns off automatically
Input and power consumption is reduced if no signal
is input for approx. 2 minutes. The light lights
again when a signal is input or any key is
pressed. In Light Cutoff, the ON/STANDBY
indicator lights in orange. (page 66)
Standby
approx. 2 minutes, the power turns off
automatically, and the unit enters standby
mode.
Off: You can deactivate the With No Input.
*7
*8 *9
: When set to "Standard," the
*11
: If no signal is input to the unit for
The Connection/Power Menu
35