Sony VPL-PHZ10 Operating Instructions Manual page 39

Setting items
Panel
*6
Alignment
*7
Color Matching
Notes
*1: Since the HV Keystone/Corner Keystone adjustment is an electronic correction, the
image may deteriorate.
*2: Normally, filter cleaning is performed automatically. However, it is not performed
when the projector is installed at an angel within the range illustrated below.
*3: Since Digital Shrink uses electronic correction, the image may deteriorate.
*4: If you press the ENTER button while adjusting with Digital Shrink, the projector
switches to the shift adjustment.
*5: For VPL-PHZ10, the function is available when "Aspect" is set to an item other than
"4:3".
*6: Depending on the adjustment value of "Panel Alignment," the color and resolution
may be changed.
*7: The brightness and color of the projected image may not match completely, even
after you adjust "Brightness" and "Color."
Item descriptions
This feature allows you to adjust the gaps in the color of
characters or the picture.
When set to "On," "Adjust Color" and "Pattern Color" can be
assigned and adjusted.
Adjust Item: Selects how to make adjustments from below.
Shift: Shifts the whole picture and makes adjustments.
Zone: Selects the desired range and makes adjustments.
Adjust Color: Assigns the desired color to adjust the gaps in
color. Select "R" (Red) or "B" (Blue) to make adjustments based on
"G" (Green).
Pattern Color: Select "R/G" (Red and Green) or "R/G/B" (White,
all colors) when "Adjust Color" is "R" (Red). Select "B/G" (Blue and
Green) or "R/G/B" (White, all colors) when the "Adjust Color" is
"B" (Blue).
Adjust: The shift adjustment and zone adjustment of the color
selected in "Adjust Color" can be made with /// keys.
Reset: The panel alignment settings are initialized to their factory
preset values.
Adjust/Reset: For correcting the brightness and color of the
whole projected image manually from the signal level in six steps.
The Installation Menu
39