Using the E‑Gel
Install hardware
‑ Gel
E
™
Imager Gel Documentation System User Guide
™
Connect the E‑Gel
Base
1. Place the E‑Gel
™
iBase
™
™
the E‑Gel
iBase
Imager Light Base.
2. Connect the DC connector cable between the E‑Gel
™
E‑Gel
Imager Light Base.
3. Connect the Universal 12 V power port at the rear of the E‑Gel
Base.
4. The E‑Gel
™
™
iBase
™
Imager Adaptor Base
Install the hardware for the E‑Gel
Base as described in the following section.
™
To install the E‑Gel
Imager Light Base, see "Install hardware" on page 14.
Appendix H Products no longer supported
™
iBase
Device with the E‑Gel
™
™
Device on E‑Gel
Device should be positioned to fit in the niches on the E‑Gel
Device is now ready for use with the E‑Gel
™
Imager Camera Hood and E‑Gel
‑ Gel
Using the E
™
Imager Adaptor Base
™
Imager Light
Imager Light Base. The pegs under
™
™
iBase
Device and the
™
Imager Light
™
Imager.
™
Imager Adaptor
H
™
57