Appendix I Safety; Safety Features; Safety Requirements - Thermo Scientific E‑Gel 4466611 User Manual

I

Safety features

Safety requirements

‑ Gel
E ™ Imager Gel Documentation System User Guide
WARNING! GENERAL SAFETY. Using this product in a manner not specified in the
user documentation may result in personal injury or damage to the instrument or
device. Ensure that anyone using this product has received instructions in general
safety practices for laboratories and the safety information provided in this
document.
·
Before using an instrument or device, read and understand the safety information
provided in the user documentation provided by the manufacturer of the
instrument or device.
· Before handling chemicals, read and understand all applicable Safety Data Sheets
(SDSs) and use appropriate personal protective equipment (gloves, gowns, eye
protection, and so on). To obtain SDSs, see the "Documentation and Support"
section in this document.
• An internal sensor prevents accidental electrocution when the tower is lifted off
the base by automatic circuit cut-out.
• This system has automatic shut-down when not in use for more than 20 minutes.
• Verify that all devices are turned off before making any connections.
• Do not block the ventilation openings of any parts of the E‑Gel
its sub-assemblies.
™
• Place the E‑Gel Imager unit at least 30 cm (12 inches) away from the walls and
ceiling.
• Do not store below −10°C. The recommended operating conditions for the
™
E‑Gel Imager are 25°C (78°F) ± 5°C, 55% relative humidity, up to 2000 m
altitude. Storage conditions: 10°C to 40°C; 50–80% humidity; up to 2000 m
altitude.
• Do not store the system in direct sunlight or in the direct flow of the air
conditioner.
• Do not clean the system with harmful solvents. Only use a soft cloth dampened
with water.
• Intended for indoor use only.
Safety
™
Imager unit or of
63