Repeater Settings Parameters; Handset Settings Parameters - Yealink VP59 Administrator's Manual

Administrator's Guide for VP59/SIP-T58A/CP960 IP Phones
features.ms.1.slave_handset_number = 2
features.ms.1.mode = 0
After provisioning, users cannot switch the active call between the phone and handset. Only the device which is dur-
ing the call can initiate a new call. If users not in a call try to initiate a call on the phone/handset, the phone/handset
screen will prompt "Path Busy".
Group 2:
features.ms.1.slave_handset_number = 4
features.ms.1.mode = 1
After provisioning, when the handset is during the call, users can retrieve the call after off-hook on the phone. When
the phone is during the call, users can push the call to the handset.

Repeater Settings Parameters

Parameter static.base.repeater_mode.enable
Description It configures the repeater mode to extend the radio coverage of the phone.
0-Off
Permitted
1-RT10/RT20
Values
2-RT30
Default 0
Phone UI
DECT Settings > Repeater Mode > Repeater Mode
[1]
If you change this parameter, the phone will reboot to make the change take effect.

Handset Settings Parameters

Parameter custom.handset.eco_mode.enable
It enables or disables the eco mode to greatly reduce the transmission power and signal output when
Description
the phone is in the talk mode.
-1-Do not modify the configuration.
Permitted
0-Disabled
Values
1-Enabled
Default -1
Supported
All handsets except DD phones
Devices
Handset UI OK > Settings > System Settings (Basic Settings) > Eco Mode
Parameter custom.handset.missed_call_notify_light.enable
It enables or disables the message key LED to flash red when the handset misses a call.
Description
Note: It will take effect on all handsets that are registered on the same phone. It works only if "stat-
ic.auto_provision.handset_configured.enable" is set to 1 (Enabled).
-1-Do not modify the configuration.
Permitted
0-Disabled
Values
1-Enabled
125
[1]
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg