Land Grid Array; Expansion Interface Ii - Analog Devices ADSP-BF518F EZ-Board Manual

Land Grid Array

side of the board. See
"VisualDSP++ Install and Session Startup" on page 1-9
information.
For more information about emulators, contact Analog Devices or go to:
http://www.analog.com/processors/tools/blackfin
Land Grid Array
The ADSP-BF518F EZ-Board has provisions for probing every port pin
and the EBIU interface of the processor on connectors
tor locations are intended for use with a Tektronix DMAX logic analyzer
connector, but can be probed with any oscilloscope or logic analyzer. For
pinout information, refer
page B-1.
For more information on the Tektronix DMAX logic analyzer interface,
go to the Tektronix Web site.

Expansion Interface II

The expansion interface II allows an Analog Devices EZ-Extender
custom-design daughter board to be tested across various hardware plat-
forms that have the same expansion interface.
The expansion interface II implemented on the ADSP-BF518F EZ-Board
consists of four connectors, three of which are 0.1 in. shrouded headers
( ), and the last of which is a Samtec QMS series header (
P2—4
nectors contain a majority of the ADSP-BF518F processor's signals. For
pinout information, go to
page B-1. The mechanical dimensions of the expansion connectors can be
obtained by contacting
1-26
"CCES Install and Session Startup" on page 1-5
to"ADSP-BF518F EZ-Board Schematic" on
"ADSP-BF518F EZ-Board Schematic" on
Technical Support.
ADSP-BF518F EZ-Board Evaluation System Manual
or
for more
.
. The connec-
P5—7
®
or a
). The con-
J1