Jtag Interface; Land Grid Array - Analog Devices EZ-Board ADSP-BF518F Manual

JTAG Interface

JTAG Interface
The JTAG connector (
debug session to the ADSP-BF518F processor. The debug agent operates
only when the external 5V wall adaptor is used (
EZ-Board from a battery or USB bus power, the debug agent is not
powered.
The standalone debug agent can be removed, and an external emulator
can be attached to the EZ-Board. Be careful not to damage the connectors
when removing the debug agent. The emulator connects to
side of the board. See
information.
For more information about emulators, contact Analog Devices or go to:
http://www.analog.com/processors/blackfin/evaluationDevelop-
ment/crosscore/

Land Grid Array

The ADSP-BF518F EZ-Board has provisions for probing every port pin
and the EBIU interface of the processor on connectors
tor locations are intended for use with a Tektronix DMAX logic analyzer
connector, but can be probed with any oscilloscope or logic analyzer. For
pinout information, refer
page B-1.
For more information on the Tektronix DMAX logic analyzer interface,
go to the Tektronix Web site.
1-22
) allows the standalone debug agent to connect a
P1
"EZ-Board Installation" on page 1-4
.
to"ADSP-BF518F EZ-Board Schematic" on
ADSP-BF518F EZ-Board Evaluation System Manual
). When operating the
J3
on the back
P1
for more
. The connec-
P5—7