Uart Setup Switch (Sw10); Reset Push Button (Sw11) - Analog Devices ADSP-BF518F EZ-Board Manual

UART Setup Switch (SW10)

The UART setup switch (
GPIO pins of the processor. Position 4 is used to place the
the processor in a loopback condition. The jumper connects the
line of the processor to the
required when a POST program is run to test the serial port interface. By
default, is
SW10

Reset Push Button (SW11)

The reset push button (
• Processor (
The reset push button does not reset the following ICs.
• SDRAM (
• Audio codec (
• Digipot (
The reset push button does not reset the standalone debug agent once the
debug agent is connected to a personal computer (PC). After communica-
tion between the debug agent and PC is initialized, pushing a reset button
does not reset the USB chip on the debug agent. The only way to reset the
USB chip on the debug agent is to power down the EZ-Board.
ADSP-BF518F EZ-Board Evaluation System Manual
ADSP-BF518F EZ-Board Hardware Reference
) configures the
SW10
UART0_RX
, , , .
ON OFF ON OFF
) resets the following ICs.
SW11
), parallel flash (
U12
), eMMC (
U14 U16
), (
U1 UART0 U21
), power (
U7 VR1—5
UART0
signal of the processor. This is
), and Ethernet IC (
U5
)
), schmitt trigger hex inverter (
)
signals from the
port of
UART0
UART0_TX
)
U4
)
U6
2-11