Removing The Unit From The Skid Using Rigging; Removing From Skid With A Forklift - Vertiv Liebert CW Series Installer And User Manual

3. Remove the lag bolts from each bracket located around the base, and remove the brackets.
4. Lift the unit off the skid to an elevation point where the skid is not supporting the weight of the unit and remove
the skid from under the unit.
Figure 4.3 Removing from skid with a forklift
3.3.2 Removing the Unit from the Skid Using Rigging
1. Use the center-of-gravity indicators on the unit panels to determine the position of the slings.
• The slings shall be equally-spaced on either side of the center-of-gravity indicator
2. Place the slings and between the bottom rails of the unit and the skid as shown in Figure 4.4 on the facing
page.
NOTE: Unit is shown without packaging. These instructions may be followed with or without the outer
packaging in place.
26
Item Description
1 Alignforklift withfront or rear of unit.
2 Insert tinescompletely under base of unit.
3 Remove lagboltsandbrackets
4 Lift unit andremove skid.
Vertiv | Liebert® CW™Installer/User Guide