Push-In Gasket To Access Screw Holes; Place Assembled Panels And Ec Fans On Top Of Unit - Vertiv Liebert CW Series Installer And User Manual

5. Attach the 2 side panels to each end of the rear-panel assembly by pushing-in the gasket/insulation to access
the screw holes and using sheet-metal screws as shown in Figure 7.9 below.
Figure 7.9 Push-in Gasket to Access Screw Holes

6.2.3 Place assembled panels and EC fans on top of unit

1. Lift the assembled plenum panels and place on top of the unit, Figure 7.10 on the facing page.
NOTE: Figure 7.10 on the facing page shows a non-grilled rear plenum as an example. If your unit is
rear-discharge, the rear plenum panels have grilles.
2. Make sure that the panels fit snugly along the collar flange on top of the unit, and temporarily install clamps,
Figure 7.10 on the facing page, to hold the panels to the collar flange for final attachment.
54
Item Description
1 Side panel
Vertiv | Liebert® CW™Installer/User Guide