Removing The Ups From The Shipping Pallet - Vertiv Liebert EXS Installer/User Manual

2.2.1 Removing the UPS from the Shipping Pallet

1. Using a forklift, pallet jack, or other lifting device, move the packaged unit as close as practical
to the intended installation location.
2. Remove the protective packing, see Figure 2.3 below.
Figure 2.3 Protective Packaging and Ramp
Item
1
2
3. Locate the included accessories in their packed location on top of the UPS, and set them aside.
4. Unbolt the shipping brackets from the pallet with a 16-mm (5/8-in.) wrench or socket:
• Remove the front, lower panel from the UPS, and unbolt the front shipping bracket.
• Unbolt the shipping bracket from the rear of the UPS.
• Retain the brackets to secure the installed UPS to the floor, if required.
5. Raise the leveling feet so that they will not interfere with the ramp when moving the UPS.
6. Place the ramp onto the pallet at the front of the UPS, and gently roll the UPS down the ramp
to the floor then into the installation position, see Figure 2.3 above.
7. Lower the leveling feet to fix the UPS in the location.
22
Description
Protective packaging
Ramp
Vertiv | Liebert® EXS™ Installer/User Guide