Slide Ec Fan Out Of The Unit - Vertiv Liebert CW Series Installer And User Manual

7. Disconnect high-voltage and low-voltage fan-motor wiring from the fan-motor electric component inside the
electric panel. Cut cable ties as needed.
8. Using the removal device shown inserted in Figure 11.4 below, slide the fan module out through the front of the
unit.
9. To reinstall the fan module, reverse these steps. Remove the field-supplied fan-removal device before resuming
operation.
NOTE: Refer to the unit's electrical schematic for specific wire-attachment points.
Figure 11.4 Slide EC fan out of the unit
92
Item Description
1 Rear frame channel (right-side panel not shown)
2 Front channel
3 Fan-removal devices
Vertiv | Liebert® CW™Installer/User Guide