Table of Contents
Advertisement
Assembling System Phones
Desk Mounting (Stand Required for MLS-34D)
A Plug one end of the handset
cord into the jack on the handset and
the other end into the small jack on the
left side on the bottom of the phone.
B Plug one end of the phone cord
into the big jack on the bottom of the
phone. Push the cord in place along
the channel on the bottom of the
phone.
Wall Mounting (Stand Required)*
Reverse the plastic hook that sits
in the earpiece part of the handset
cradle.
CAUTION:
Do not unscrew the bottom of
the phone. To do so will
expose you to a risk of eletri-
cal shock.
*These wall mounting instructions apply to corded MLS-model phones only.
To wall mount an MLC-6 cordless phone, follow the instructions in the
Installation and Troubleshooting booklet provided with the phone.
To install the telephone stand,
gently place the phone upside down
with the low end of the phone to your
right. Insert the tab on the narrow end of
the stand into the right slot on the
bottom of the phone. Then insert the
other tab into the left slot pushing the
stand down and slightly inward until the
tab locks into place.
Install the telephone stand. To
snap the stand onto the bottom of the
phone, gently place the phone upside
down with the low end of the phone to
your right. Insert the tab on the narrow
end of the stand into the left slot on the
bottom of the phone. Then insert the
other tab into the right slot, pushing the
stand down and slightly inward until the
tab locks into place.
Slide the Quick Reference card
under the phone.
NOTES:
If you wall mount a display phone, the
display may be difficult to read, so desk
mounting is recommended.
Position MLC-6 cordless system
phones at least 20 feet away from the
control unit.
Insert the phone cord through the
center of the stand and plug it into the
jack on the bottom of the phone, then
plug the other end into the modular wall
jack. Push any excess cord into the
space inside the stand, then mount the
phone on the wall jack using the screw
keyholes on the bottom of the stand. For
proper mounting, the wall jack must be
an AT&T 630B connecting block. Finally,
connect the handset cord as described
in "Desk Mounting." step 1A.
Installing the Hardware 2-9
Advertisement
Table of Contents
