Safety Standards; Preparation By The Customer Responsible For - PRODEM PDS Series Operating Instructions Manual

GENERAL
INFORMATION
SAFETY RULES
The attachment has been constructed in conformity with the safety standards listed below:
UNI EN ISO 12100
Machine safety - Fundamental Concepts, General design principles, Risk assessment and risk reduction.
UNI EN ISO 13857
Safe Distances from Machinery - Safe distances for preventing the upper limbs from reaching dangerous
areas.
UNI EN 349
Safe Distances from Machinery - Minimum distances to avoid crushing parts of the human body.
UNI EN 474-1
Machine Safety - General Requirements.
UNI EN 474-5
Machine Safety - General Requirements - Requirements for hydraulic excavators.
ATTENTION!
The standards in this manual may not protect from specific situations that may arise during different
stages of work.
PREPARATIONS THE CUSTOMER IS RESPONSIBLE FOR
Except where contractually agreed otherwise, the customer is normally responsible for:
Preparing the environment / work area and work equipment in accordance with specific safety and
required by the applicable laws in the country to use the equipment;
Check in accordance with specific safety and required by the applicable laws in the country to use the
equipment correctly matched to the machine;
Power hydraulic equipment, in accordance with the regulations in the country of use and the
specifications in this manual;
ATTENTION!
It is a customer / end user responsibility to integrate the instructions contained in this user manual and
system maintenance / assembly and provide any additional information to the operator.
9
www.prodem-attachments.com
Translated by the original