Glossary And Symbols - PRODEM PDS Series Operating Instructions Manual

INTRO
SECTION

GLOSSARY AND SYMBOLS

This paragraph explains the abbreviations used and the meaning of the symbols used to indicate the
operator qualifications and the state the attachment. Their use allows the information necessary for the
correct and safe use of the attachment to be communicated quickly and unequivocally.
DANGEROUS AREA:
An area inside and/or near the attachment in which the presence of an exposed person constitutes a risk
for the health of that person (See safety rules cited).a
EXPOSED PERSON:
Any person wholly or partially inside a dangerous area (See safety rules cited).
OPERATOR:
A person appointed to install, operate, adjust, perform maintenance on, clean, repair or transport the
attachment (See safety rules cited).
MAN-OPERATING MACHINE INTERACTION:
Any situation in which an operator interacts with the attachment in any of the operational phases at any
time in its life.
OPERATOR QUALIFICATION:
Minimum skill level that the operator must have to perform the operation described.
NUMBER OF OPERATORS:
The number of operators sufficient to perform the operation described and derived from a careful analysis
performed by the manufacturer for which the use of a different number of employees could prevent
obtaining the expected result or place the safety of the personnel involved in danger.
STATE OF THE OPERATING MACHINE:
The state of the operating machine includes its mode of operation, for example, automatic, jog, stopped,
etc., the condition of the safety features on the operating machine, such as protections included,
protections excluded, emergency stop pressed, type of insulation of the sources of energy, etc.
RESIDUAL DANGER:
A danger that cannot be eliminated or sufficiently reduced through design, against which the protections
are not (or are not totally) effective; the Manual provides information of its existence and instructions and
warnings to allow it to be overcome (See safety rules cited).
SAFETY COMPONENT:
This is a component used to provide a safety function and who failure or poor operation has a negative
effect on the safety and/or health of exposed persons (such as lifting equipment, fixed, mobile or
adjustable protections, or an electrical, electronic, optical, pneumatic or hydraulic device that is
interlocked with a protection, etc.).
INTENDED USE:
The operation with Interchangeable attachment must be in accordance with the information reported
into the instructions for use (Directive 2006/42/EC Annex I, 1. 1 . 1 ) .
5
www.prodem-attachments.com
Translated by the original