Rfc-1483 Pvc Configuration Example; Configuration Example Procedure - Cisco Catalyst 2900 XL Series Installation And Configuration Manual

RFC-1483 PVC Configuration Example

PVC VLAN/Switch Connections
4 Connects Catalyst
switch (2) to Cisco router on
VLAN3
5 Connects Catalyst
switch (2) to Cisco router on
VLAN1

Configuration Example Procedure

To configure the RFC-1483 PVC example in Figure C-2, follow these steps:
Step 1
Step 2
Step 3
Step 4
Step 5
Configure VLANs on the Catalyst 2924M XL Switch (1)
To configure VLANs on the Catalyst 2924M XL switch (1), use the Enterprise Edition
Software to do the following:
Step 1
Step 2
Step 3
Step 4
Refer to the Catalyst 2900 Series XL Enterprise Edition Software Configuration Guide for
information about the following:
•
Assigning a management domain
C-10
Catalyst 2900 Series XL ATM Modules Installation and Configuration Guide
VCD
2924M XL
103
2924M XL
104
Configure VLANs on the Catalyst 2924M XL switch (1).
Configure VLANs on the Catalyst 2924M XL switch (2).
Configure PVCs on the ATM Network.
Configure PVCs on Catalyst 2924M XL switch (1).
Configure PVCs on Catalyst 2924M XL switch (2).
Assign a management domain.
Define VLANs.
Group switch ports to VLANs.
Check the trunk mode.
VLAN
VPI ID VCI
0 3 103
0 1 104
Peak Average
Rate Rate
(kbps) (kbps)
30,000 10,000
30,000 20,000
Burst
Cell
Rate
32
default