Cisco Catalyst 2900 XL Series Installation And Configuration Manual page 86

LANE Configuration Example
Step 7
Step 8
Step 9
Step 10
Step 11
C-6
Catalyst 2900 Series XL ATM Modules Installation and Configuration Guide
Start and bind the LECS on the Catalyst 5000 switch by entering the interface
atm0, the lane config database_name, and the lane auto-config-atm-address
commands:
ATM# configure terminal
Enter configuration commands, one per line, End with CNTRL/Z.
ATM(config)# interface atm0
ATM(config-if)# lane config test
ATM(config-if)# lane auto-config-atm-address
ATM(config-if)# ^Z
ATM#
Save the configuration to NVRAM by entering the write memory command.
Start the LEC for the ELAN named default on the Catalyst 5000 switch by
entering the interface atm0.1 and the lane client ethernet 1 default commands:
ATM# configure terminal
Enter configuration commands, one per line.
ATM(config)# interface atm0.1
ATM(config-subif)# lane client ethernet 1 default
ATM(config-subif)# ^Z
ATM#
Start the LEC for the ELAN named engineering on the Catalyst 5000 switch by
entering the interface atm0.2 and the lane client ethernet 2 engineering
commands:
ATM# configure terminal
Enter configuration commands, one per line.
ATM(config)# interface atm0.2
ATM(config-subif)# lane client ethernet 2 engineering
ATM(config-subif)# ^Z
ATM#
Save the configuration to NVRAM by entering the write memory command.
End with CNTL/Z.
End with CNTL/Z.