Cisco Catalyst 2900 XL Series Installation And Configuration Manual page 85

Step 3 Configure the BUS and LES for the ELAN engineering on the Catalyst 5000
switch by entering the interface atm0.2 and lane server-bus ethernet
engineering commands at the Catalyst 5000 switch management console:
ATM(config)# interface atm0.2
ATM(config-if)# lane server-bus ethernet engineering
ATM(config-if)# ^Z
ATM#
Save the configuration to NVRAM by entering the write memory command.
Step 4
Configure the LECS database on the Catalyst 5000 switch with the LANE server
Step 5
address obtained in Step 1. Replace the asterisks ( ** ) with the subinterface
number of the interface in which the LES and BUS is configured. In this
example, that number is 01 for the ELAN named default and 02 for the ELAN
named engineering.
Enter the lane database database_name, name elan_name server-atm-address
atm_address, and the default-name elan_name commands:
ATM(config)# lane database test
ATM(lane-config-database)# name default server-atm-address
39.000000000000000000000000.00605C28DA21.01
ATM(lane-config-database)# default-name default
ATM(lane-config-database)# name engineering server-atm-address
39.000000000000000000000000.00605C28DA21.02
ATM(lane-config-database)# ^Z
ATM#
The LECS database is created with the following particulars:
•
The LECS database name is test.
•
The ELAN names are default and engineering.
•
The LES ATM NSAP address is
39.000000000000000000000000.00605C28DA21.01 for the ELAN named
default.
•
The LES ATM NSAP address is
39.000000000000000000000000.00605C28DA21.02 for the ELAN named
engineering.
Save the configuration to NVRAM by entering the write memory command.
Step 6
Configuration Example Procedure
Configuration Examples C-5