Configure Catalyst 2924M Xl Switch - Cisco Catalyst 2900 XL Series Installation And Configuration Manual

RFC-1483 PVC Configuration Example

Configure Catalyst 2924M XL Switch (1)

To configure Catalyst 2924M XL switch (1), do the following:
Step 1
Step 2
Step 3
Step 4
C-16
Catalyst 2900 Series XL ATM Modules Installation and Configuration Guide
Start a session on the ATM module by entering the session 1 command at the
2924M XL management console:
switch# session 1
ATM>Entering Console for module in slot 1
Type "^G" to end this session
Press RETURN to get started!
ATM>
Set up PVC1, PVC2 and PVC3 on the Catalyst 2924M XL switch (1) by entering
the enable command and providing the information as shown in the following
example.
ATM > enable
ATM# configure terminal
Enter configuration commands, one per line. End with CTRL/Z.
ATM(config)# interface atm1
ATM(config-if)# atm pvc 100 0 100 aal5snap
ATM(config-if)# atm pvc 101 0 101 aal5snap 50000 50000 32
ATM(config-if)# atm pvc 102 0 102 aal5snap 30000 30000 4
ATM(config-if)# ^Z
Bind PVC1 and PVC2 to VLAN1, and bind PVC3 to VLAN2 by entering the
configure terminal command and providing the information as shown in the
following example.
ATM# configure terminal
Enter configuration commands, one per line. End with CTRL/Z.
ATM(config)# interface atm1
ATM(config-if)# atm bind pvc vlan 100 1
ATM(config-if)# atm bind pvc vlan 101 1
ATM(config-if)# atm bind pvc vlan 102 2
Verify the setup on the Catalyst 2924M XL switch (1) by entering the show atm
vlan command.
ATM# show atm vlan