Cisco Catalyst 2900 XL Series Installation And Configuration Manual page 95

Step 9 Create PVC5 on the ATM network by entering the enable command and
providing the information as shown in the following example.
Switch> enable
Password: <password>
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# int atm0/0/1
Switch(config-if)# atm pvc 0 104 interface atm0/0/2 0 104
Switch(config-if)# ^Z
Switch#
Verify the setup of PVC5 by entering the show atm vc interface command.
Step 10
Switch# show atm vc interface atm0/0/1
The following display appears:
Interface VPI VCI
ATM0/0/0 0 5
ATM0/0/0 0 16
ATM0/0/1 0 100
ATM0/0/1 0 103
ATM0/0/1 0 104
Type X-Interface
PVC ATM2/0/0
PVC ATM2/0/0
PVC ATM0/0/1
PVC ATM0/0/2
PVC ATM0/0/2
Configure PVCs on the ATM Network
End with CNTL/Z.
X-VPI X-VCI Encap
0 50 QSAAL
0 34 ILMI
0 100
0 103
0 104
Configuration Examples C-15
Status
UP
UP
UP
UP
UP