Configure Pvcs On The Atm Network - Cisco Catalyst 2900 XL Series Installation And Configuration Manual

RFC-1483 PVC Configuration Example

Configure PVCs on the ATM Network

To configure PVCs on the ATM network, do the following on the LS1010 ATM switch:
Step 1
Step 2
Interface
ATM0/0/0
ATM0/0/0
ATM0/0/0
Step 3
C-12
Catalyst 2900 Series XL ATM Modules Installation and Configuration Guide
Create PVC1 on the ATM network by entering the enable command and
providing the information as shown in the following example.
Switch> enable
Password: <password>
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# int atm0/0/0
Switch(config-if)# atm pvc 0 100 interface atm0/0/1 0 100
Switch(config-if)# ^Z
Switch#
Verify the setup of PVC 1 by entering the show atm vc interface command.
Switch# show atm vc interface atm0/0/0
The following display appears:
VPI VCI Type
0 5 PVC
0 16 PVC
0 100 PVC
Create PVC2 on the ATM network by entering the enable command and
providing the information as shown in the following example.
Switch> enable
Password: <password>
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# int atm0/0/0
Switch(config-if)# atm pvc 0 101 interface atm0/0/2 0 101
Switch(config-if)# ^Z
Switch#
X-Interface X-VPI
ATM2/0/0 0
ATM2/0/0 0
ATM0/0/1 0
End with CNTL/Z.
X-VCI Encap Status
48 QSAAL UP
32 ILMI UP
100 UP
End with CNTL/Z.